BLW-54CW only supports WDS-Bridge in AP mode. Now we take BLW-54CW for example, by using two BLW-54CW to set the WDS-Bridge.

1. Please set both BLW-54CW to Access Point mode. You have to hold the reset button for 3reconds, and then the AP mode LED will be on, that means you have successfully switched to AP mode.


2. Please set a static IP address for your PC, the static IP address must be in the same segment with BLW-54CW(the default IP address of BLW-54CW is 192.168.1.1).


3. Going to the configuration web page: http://192.168.1.1; the account is "admin", the password is "0000".


4. You may change the default static IP address of BLW-54CW, however, the changed static IP address must be the same with the segment on your area network.
For example, your area network is 192.168.1.X; the first BLW-54CW's IP address is 192.168.1.2; the second BLW-54CW's is 192.168.1.3.


5. Checking the wireless MAC address of both BLW-54CW (the wireless MAC address should be seen on the "Status" page).


6. Enable the Point to Point Bridge(WDS) mode, and key in the wireless MAC address of  2nd BLW-54CW on the WDS mode configuration page of 1st BLW-54CW; then follow the same step to set the wireless MAC address of 1st BLW-54CW on the WDS mode configuration page of 2nd BLW-54CW.


7. Apply all the settings, and restart the BLW-54CW.

8. Please use RJ-45 cable to connect your PC to the BLW-54CW LAN port. If your PC gets the IP address from your area network, that means you've successfully set up WDS-Bridge.